Top-rated independent heating and cooling across California's Central Valley and the Sierra foothills

Furnace Replacement in Fresno, CA

When a heat exchanger cracks or the cabinet has rusted through, repair stops making sense, and that is where furnace replacement in Fresno starts. We look at venting, gas line capacity, return air sizing and where the unit sits, because attic installs and hallway closets need different approaches. Old ductwork gets inspected too, since a new furnace pushing through leaking runs wastes the work. We handle the swap and the startup checks. Reach us by phone or drop your details in the quote form.

Call (888) 381-2953

A real person answers
Open 7 days
Written quote before work starts

Taking calls until 5:00 PM PT

All major brands repairedCarrier Trane Lennox Goodman Rheem York American Standard Bryant

What brings Fresno homeowners to this job

It kicks on, runs two minutes, shuts off, then starts again Short cycling from oversizing, failing limit switch or flame sensor
A tech told us the heat exchanger is cracked Cracked heat exchanger, combustion safety, replacement territory
Our furnace is old enough that parts take a week to find Obsolete control board or blower motor, end of service life

What a furnace replacement actually involves

We start by measuring the house, not by matching the sticker on the old unit. Load calculations tell us the BTU output the home needs, which often differs from what was installed years ago. Then we shut down gas and power, disconnect the old furnace, and remove it. The new unit gets set, connected to gas, flue and electrical, tied into the existing ductwork, and wired to the thermostat. We test firing, temperature rise and safety controls before we leave, and we haul the old equipment away.

What we check and install along the way

A furnace swap is a good moment to fix what the old install got wrong. We look at the flue and venting, the gas line size, the condensate route on high-efficiency units, and the return air opening, since a starved return shortens the life of any furnace. We check duct connections at the plenum for leaks and loose transitions. New filter rack, new thermostat if the old one cannot talk to the new control board, and a fresh drain line where one is required.

How we decide replacement beats repair

We tell you what we find and let the numbers make the case. A cracked heat exchanger, a failed control board on a unit near the end of its service life, or a cabinet with heavy rust means replacement. A bad igniter, flame sensor or capacitor on an otherwise sound furnace means heating repair, and we will say so. Age matters, but so does repair history. Two service calls a season on the same unit usually points one direction. You get both options and the reasoning behind them.

Fresno coverage

From Fresno we also cover Clovis, Sanger, Kingsburg, Selma, Reedley, Madera, Kerman and the smaller communities along Highway 99.

93715
93716
93717
93718
93720
93721
93722
93723

Fresno permits, codes and utility programmes

Fresno takes both electric and gas service from Pacific Gas and Electric Company (PG&E).

Before you buy, look at TECH Clean California heat pump incentives and Energy Upgrade California. We will not promise something that closed last quarter, but we will tell you what is running when we quote.

California Title 24, Part 6 applies to a changeout here, which normally means a permit, with HERS verification and CF2R/CF3R registration on most changeouts. City of Fresno Planning and Development Department, Building and Safety Services handles them.

The federal 25C Energy Efficient Home Improvement Credit applies to qualifying equipment, and the efficiency tier it requires is worth checking before you choose a system.

Related furnace installation work in Fresno

All furnace installation in Fresno → · Furnace Replacement across the region →

The same on every visit

The quote comes first, in writing

Covering 123 cities across California, Nevada.

Phones answered by people

Open 7 days, 8:00 AM to 5:00 PM PT.

Independent of every manufacturer

Carrier, Trane, Lennox, Goodman and more. We are not an authorized dealer for any of them.

Furnace Replacement in Fresno — quick answers

How long does a furnace replacement take?

Most straightforward swaps are a single day. Attic installs, tight closets, venting changes or gas line work can push into a second day, and we will tell you which one you are looking at before we start.

Do I have to replace my AC at the same time?

No. A furnace and an air conditioner can be replaced separately. That said, if both are the same age and share a coil and blower, doing them together avoids paying for the same labor twice.

How soon can you get to my house in Fresno?

Call us and we will give you the first open slot on the Fresno schedule, usually same day or next day depending on how the heat is running that week. During a long stretch above 105 degrees the board fills early, so morning calls get more options. Tell us if anyone in the home is elderly, very young or has a health condition and we will move you up the list. Before we arrive you can check the thermostat batteries and settings, look for a tripped breaker, change a dirty filter, clear leaves and dust away from the outdoor unit, and make sure supply vents are open.

How it works

Step 1
Tell us the symptom
Call or fill in the quote form. We ask what changed, when it started, and what the thermostat reads. That tells us whether to bring parts for a cooling fault or a heating fault.
Step 2
We diagnose on site
A technician checks the thermostat, the electrical side, airflow through the filter and coil, refrigerant pressures, and the outdoor unit. You get told what failed and why, in plain words, before anything is replaced.
Step 3
Repair and verify
We make the repair, then run the system and measure the results at the vents. If a part needs ordering, we say so and give you a realistic window instead of a vague promise.

Call (888) 381-2953

A real person answers
Open 7 days
Written quote before work starts

Why homeowners call us

Built for real valley heatWe work in areas where afternoons sit above 110 degrees and systems run for months without a break. That shapes how we size repairs, check capacitors and contactors, and judge whether a compressor is genuinely done.
Attic and package unitsPlenty of homes across the region run attic air handlers or rooftop package units instead of a garage furnace and a side-yard condenser. We are used to the access, the duct runs, and the drain issues those setups bring.
Dust and debris we expectAg dust, cottonwood fluff and grass clippings pack condenser coils and starve a system of airflow. We clean what we find and show you the difference, rather than adding refrigerant to a unit that just could not breathe.
Heating too, not only ACFurnace repair, heat pump faults and no-heat calls get the same attention as summer work. Ignition problems, cracked or failing components and short cycling all get diagnosed before we recommend anything larger.
All major brands, gas & electricFrom Carrier and Trane to Lennox, Goodman, Rheem and Bryant, serviced independently.
Straight answersWhen a replacement beats a repair, we tell you, sometimes before we roll a truck.